A 3D printed 28mm scaled figures of the Damsel

They will come with Square resin printed bases, unless commented for Circle bases. 

Sculpted for the https://www.patreon.com/highlands_miniatures




Please note that this is a print on demand figure, using Resin 3D printing via Anycubic Mono/MonoX printers. We endevour to print the models as fast as possible, but at peak times this can cause a bit of a delay. Any questions on timing or the current Queue, please email us and we would be more than happy to discuss the current situation and/or requirements. 


It will be printed in 0.05 resolution, so some print lines/stepping will occur. Though many of these will disappear once primed with an areosol/can primer. If a higher resolution is required, please raise a request via our Custom Printing form or email us via mrleesminis@gmail.com


We clean all the models to remove supports to the best of our ability, though some additional clean up might be required. 

Damsel on Foot

    • Mr Lee's Minis Facebook