Halfling Spearmen in 10mm, sculpted by Alex Huntley from Warploque Miniatures. 

Printed in Resin on an Anycubic Mono or MonoX 3D printer under license by Warploque Miniatures merchant account on Patreon - https://www.patreon.com/warploqueminiatures

 

These are single pose models. If you would prefer specific models from them, please mention in the notes at checkout. Each model/base will contain 3 Cavalry. So 5 bases is 15spearmen, 10 is 30, etc. 

For every 10 bases, one will be a Command base. 

 

Disclaimer:

Please note that this is a print on demand figure, using Resin 3D printing via Anycubic Mono/MonoX printers. We endevour to print the models as fast as possible, but at peak times this can cause a bit of a delay. Any questions on timing or the current Queue, please email us and we would be more than happy to discuss the current situation and/or requirements. 

 

It will be printed in 0.05 resolution, so some print lines/stepping will occur. Though many of these will disappear once primed with an areosol/can primer. If a higher resolution is required, please raise a request via our Custom Printing form or email us via mrleesminis@gmail.com

 

We clean all the models to remove supports to the best of our ability, though some additional clean up might be required. 

10mm Halfling Cavalry

PriceFrom £10.00
Quantity
    • Mr Lee's Minis Facebook
    0